adhesive failure
英 [ədˈhiːsɪv ˈfeɪljə(r)]
美 [ədˈhiːsɪv ˈfeɪljər]
黏合失效
双语例句
- Debonding at CFRP plate and adhesive interface is a common failure mode for NSM CFRP plate to concrete.
板-胶剥离破坏是混凝土表层嵌贴CFRP板条加固方式常见的破坏形式。 - Through introducing the performance of industrial mending adhesive and the principles to mend and listing a lot of application cases, the paper points out application scope, source of failure and right applied method of industrial mending adhesive in examining and repairing chemical equipment.
介绍了工业修补胶的性能原理及应用实例，指出了工业修补胶在化工设备检修中的应用范围、失效原因及正确应用方法。 - Adhesive bond affects the strength and failure style, too;
粘接影响接缝的破坏形式及接缝的抗剪强度； - Objective To observe the adhesive properties of cultured human tubular cells and changes of α 3 integrins after anoxia/ oxidative stress so as to evaluate the effects of changed tubular cell adhesive properties on the mechanism of ischemic acute renal failure.
目的观察体外培养肾小管上皮细胞缺氧、氧损伤后细胞粘附性及α3整合素的改变，为细胞粘附性改变在急性缺血性肾功能衰竭发病机制中的作用提供理论依据。 - A design conception on probabilistic statistics was introduced into adhesively bonded single lap joint, and finite element method was applied to analyze the factors which have important influences on the mechanical property of adhesive joint. Using 100 samples the failure probability was concluded.
将概率统计的设计观念引入单搭接粘接接头，通过有限元分析方法分析了对粘接接头力学性能影响较大的因素，并在抽样100次的情况下，分析了单搭接粘接接头失效的概率。 - Through the control of critical points as the FRP length, number of FRP layer and mechanical property of adhesive, which is useful for restraining debonding failure.
通过对纤维布粘贴层数、长度以及粘结胶力学特性等关键要素的控制，可以有效地抑制粘结剥离破坏的发生。 - Through bending experiment, adhesive materials failure point and load of toughened and not toughened samples are analyzed and the toughening modification of adhesive materials can improve the adhesive properties between CFRP and concrete.
通过弯曲试验，分析粘结材料增韧前后弯曲试件的破坏特点和破坏载荷，得出对粘结材料进行增韧改性可以提高CFRP与混凝土的粘结性能。 - Bending experiments were used to determined adhesive properties of the adhesive materials, the optimal formulation of adhesive materials was determined depending on the failure modes and maximum failure loads.
采用弯曲性能试验表征粘结材料的粘结性能，以破坏形态和最大破坏载荷值为依据，确定了加固用粘结材料的最佳增韧剂含量。 - Therefore, the study of fatigue damage and adhesive layer damage of steel bridge deck is crucial. First, this paper analyzes the representative failure phenomena of steel bridge deck in china and the Guangdong Pearl River Huangpu Bridge deck overlay problems in the process.
因此，研究钢桥面铺装的疲劳破坏和粘结层破坏显得至关重要。本文首先分析了国内部分有代表性钢桥面铺装的破坏现象以及广东珠江黄埔大桥钢箱梁桥面铺装铺装过程中存在的问题。 - Due to the tensile strength of adhesive layer larger than concrete tensile strength, Interface failure mode usually is shear failure of concrete that near the adhesive layer, and debonding failure from the loading end to the free end.
由于胶层的抗拉强度比混凝土抗拉强度要大，界面破坏一般情况下是胶层附近的混凝土发生剪切破坏，剥离破坏是从加载端向自由端破坏。 - Multi-directional C/ E composites is cascading laying adhesive structure, so only does this paper flight-cutting test on single-beam carbon fiber ( single-layer fiber) and multi-layer carbon fiber plate, which can help us to understand and master failure mechanism of the forces in the machining process.
多向C/E复合材料为层叠铺设粘接结构，只有分别对单束碳纤维丝（单层纤维布）和多层碳纤维丝板进行材料的飞切试验研究，才能深入了解加工过程力对材料的破坏机制。 - This predictive method is introduced detailedly. 2 、 The initiation and propagation of fibre damage, matrix cracking, delamination and adhesive failure of repaired composite laminates as well as coupling effect among them is investigated.
对该方法作了详细介绍。2、对楔形修补层合板的纤维断裂、基体开裂、层间分层以及胶层脱胶等损伤的萌生和扩展以及它们之间的耦合作用进行了研究。 - As a result, concentration of lactate around 10% may cause the lactate to act as "adhesive" for particles and that may lead to contact failure.
结果为10%左右浓度乳酸盐对颗粒表现出粘结剂的作用，因此导致接触失效。